The Secret of 400-051 practice exam

400-051 Royal Pack Testengine pdf

100% Actual & Verified — 100% PASS

Unlimited access to the world's largest Dumps library!

It is impossible to pass Cisco 400-051 exam without any help in the short term. Come to Certleader soon and find the most advanced, correct and guaranteed Cisco 400-051 practice questions. You will get a surprising result by our Update CCIE Collaboration practice guides.

This web site will certainly provide you with credible info concerning 400-051 exam dumps

P.S. Validated 400-051 interactive bootcamp are available on Google Drive, GET MORE:

New Cisco 400-051 Exam Dumps Collection (Question 13 - Question 22)

New Questions 13

What does a period accomplish when it is used in a SlP Dial Rule pattern that is associated with a Cisco 9971 lP Phone that is registered to Cisco Unified Communications Manager?

A. lt manages any single digit from 0 to 9.

B. lt manages any single digit from 0 to 9 or the asterisk (*) or pound (#) symbols.

C. lt is a delimiter and has no significant dialling impact

D. lt manages one or more digits from 0 to 9 or the asterisk (*) or pound (#) symbols.

E. lt manages one or more digits from 0 to 9.

Answer: B

New Questions 14

Refer to the exhibit.

A Cisco collaboration engineer is writing a report to summarize the call distribution characteristics in a Cisco Unified Contact Centre Express queue. Which three characteristics can be reported about the call distribution? (Choose three.)

A. This queue will not work because no prompt has been selected.

B. Calls to this queue can be distributed in a round-robin manner between agents.

C. Agents that are answering calls for this queue can answer calls to other queues if available.

D. Agents in this queue are expected to finish (wrap-up) a call within 60 seconds.

E. Calls to this queue are handled in the order they were received unless prioritized by the script.

F. Changing the queue name from SupportQueue to Support01 requires updates to the script.

G. Agents logged in to this queue automatically receive calls without the need to do anything else (Automatic work).

Answer: CEF

New Questions 15

Assume 18 bytes for the Layer 2 header and a 10- millisecond voice payload, how much bandwidth should be allocated to strict priority queue for three VolP calls that use a G 722 codec over an Ethernet network?

A. 331.2 kb/s

B. 261.6 kb/s

C. 238.4 kb/s

D. 347.8 kb/s

E. 274.7 kb/s

Answer: A

New Questions 16

Refer to the exhibit.

The MGCP debugs were captured on a Cisco lOS MGCP PRl gateway registered to a Cisco Unified CM. Assume that this gateway had no active calls and will not take any new calls for the next 3 minutes. What time it will send the next NTFY message to the Cisco Unified CM?

A. Jan 10 05:56:35.130

B. Jan 10 05:55:45.130

C. Jan 10 05:55:50.130

D. Jan 10 05:56:05.130

E. Jan 10 05:55:40.130

Answer: C

New Questions 17

What is the maximum number of option 66 lP addresses that a Cisco lP SCCP phone will accept and use from a DHCP server?

A. 1

B. 2

C. 3

D. 4

E. 5

Answer: A

New Questions 18

Which procedure uses H.225 messages to exchange H.245 Master-Salve Determination information?

A. H.323 early media

B. H.245 terminal capability set

C. H 225 tunneling

D. H.245 tunneling

E. H.323 Fast Connect

Answer: D

New Questions 19

Three calls are active on ephone 1. Assume ephone 2 will remain idle.

How many additional calls can be placed from ephone 1?

A. 0

B. 1

C. 2

D. 3

E. 5

Answer: C

New Questions 20

Refer to the exhibit.

A network engineer is troubleshooting a call routing issue where failed calls on the primary path (SiteA-RTR) was not sent to the secondary path (SiteC-RTR). Why is CUCM unable to extend the call setup through SiteC-RTR?

A. Stop routing on Q.931 Disconnect cause code is set to 27

B. Stop routing on Unallocated Number Flag is set to true

C. Stop Routing on User Busy Flag is set to true

D. Retry count for SlP lnvite is set to 1

E. Retry count for SlP response is set to 1

Answer: B

New Questions 21

Which two Cisco Unified Communications Manager SlP profile configuration parameters for a SlP intercluster trunk are mandatory to enable end to end RSVP SlP Preconditions between clusters? (Choose two.)

A. Set the SlP Rel1xx Options parameter to Send PRACK if 1xx Contains SDP.

B. Set the SlP Rel1xx parameter to Disabled.

C. Check the Fall Back to Local RSVP check box

D. Set the SlP Rel1xx Options parameter to Send PRACK for all 1xx Messages

E. Set the RSVP over SlP parameter to Local RSVP

F. Set the RSVP over SlP parameter to E2E

Answer: AF

New Questions 22

Refer to the exhibit.

A customer is configuring CAR costing for call. When the customer runs the costing reports calls are not being tagged correctly. Which two changes allow proper costing to be determined for these calls? (Choose two)

A. The toll free area code field must be updated to include all toll free area codes

B. A new local pattern must be added with the pattern "k "

C. A new pattern must be added for the 914 and 625 area codecs

D. The items are out of order and must be sorted with the most specific at the top

E. Overlapping area codec on the trunks must be removed

F. All external patterns must be change to include the outside access code

Answer: AB


Choose System > System Parameters > Dial Plan Configuration.

The Dial Plan Configuration window displays.

ln the Toll Free Numbers field, enter the numbers in your dial plan that can be placed without a charge.

lf the number of digits dialed equals 10 and the pattern is K (more than one digit, in this case a 10-digit number that starts with a trunk code),

the call gets classified as Local.

100% Update Cisco 400-051 Questions & Answers shared by Certifytools, Get HERE: (New 616 Q&As)